Setup instructions for every Umitent product. All guides are bilingual PDF files in English and French.

Custom canopy tent

Canopy tents

Unfolding, roof attachment, locking the frame, height adjustment and tie-downs.

Download PDF
Quick reference
  • Unfold the frame partway before putting the roof on, not after
  • Tape the roof fabric to all four corner covers before extending the frame
  • Press the corner cover down and slide the leg lock until you hear a click, on all four corners
  • Secure the centre strap once the frame is fully extended
  • Adjust leg height by pressing the lock and sliding the leg out
  • Use the tie-downs whenever there is wind
Tent walls

Tent walls

Half wall and full wall installation, connectors and fabric tension.

Download PDF
Quick reference
  • Half walls need the two connectors from the package, one on each leg
  • Open the connector by removing one screw, fit it to the leg, align the ports, screw it back
  • Slide the half wall into the tube, then repeat on the second leg
  • Use the Velcro straps to secure the fabric to the frame leg
  • Adjust fabric tension carefully and check every fastening before use
Custom flags

Flags

Pole assembly, fitting the flag and ground anchoring.

Download PDF
Quick reference
  • Connect the poles in order from smallest to largest
  • Insert the top of the pole into the bottom opening of the flag
  • Pull the flag taut so it curves properly
  • Attach the rope to the hook
  • Drive the ground spike in with a hammer, never hammer the pole itself
Small fabric backdrop

Backdrop, small

Narrow upright fabric display.

Download PDF
Quick reference
  • Match the numbers on the poles and connect them in pairs
  • Press the locking button until both terminals click together
  • Slide the fabric down over the assembled frame
  • Close the zipper along the bottom to secure the fabric
  • Insert the stand base into the bottom section last
Large fabric backdrop

Backdrop, large

Full-width fabric backwall display.

Download PDF
Quick reference
  • Match the numbers on the poles and connect them in pairs
  • Press the locking button until both terminals click together
  • Slide the fabric down over the assembled frame
  • Close the zipper along the bottom to secure the fabric
  • Insert the stand base into the bottom section last
Water tank weight

Water tank weights

Assembly, filling and draining.

Download PDF
Quick reference
  • Fit the bolt through the base plate with a washer on each side
  • Rotate to tighten until the post sits firm
  • Fill with water on site and empty before transport

Can’t find your manual?
Send us your order number and we will send the right one.

Contact us